Hi, 

I'd tested the videos bbb and sintel an booth worked fine on the mini 4, look great, vivid and fluent.

* 4096px × 1720px "sintel-1080-cfg02.mkv"

* 3840px × 2160px "bbb-3840x2160-cfg02.mkv"

Did antutu benchmark scored 33.6k with out tweaks or trick to improve it.

Did 3d marck bechmark scored 11k for ultimate and 7k for extreme test.

The eMMC test was passed with 25mb/s.

On the other hand since the previous fw a had a issue with the battery management, after the mini4 has charged complete using the wall charger, the system say it has only 1% of battery, which i have confirmed it not cause if i leave it working i does not power off, but i i leave it will shut down cause of the bad data.

Hope you could help me with it. 

Oma7144 said
Set this parameter in build.prop to true.

ro.rk.systembar.voiceicon=false

- Oma -

Oma7144 said
Set this parameter in build.prop to true.

ro.rk.systembar.voiceicon=false

- Oma -

@Oma

I tried this but i i did something wrong after reboot the mini4 doesn't start complete, y does pass the oma's splash but then the screen it's on but just black, the power button makes tablet vibrate un patrons until if finally just stop :s.

Any idea of roll back ?

In case a new firmware flash, this is not posible from a Mac does it ? The tools are all Windows

Thanks !

Oma7144 said
Use a Win7 PC and re-flash system.img (tick parameter and system).

- Oma -

Great !

I just work the system flashing, then apply the changes to the build.prop and worked too

As i didn't have any PC to use, i used a Windows 8.1 Virtual Machine in vmware fusion over Mac, i can tell you now its save to use it to flash without any problems and to install drivers and to the flashing progress.

Thanks !