PIPO M9 Pro 3g Firmware Update - Forum

Latest product reviews
ARCHOS 50 Diamond
ARCHOS GamePad2
ARCHOS Smartphones
ARCHOS TV Connect
ARCHOS 101 XS

PIPO M9 Pro 3g Firmware Update

Update Firmware Restore Message PIPO M9 Pro 3g message operation didn't do because of not supporting!

Jude TJ

New Member

Forum Posts: 9

Member Since:
2013/11/12

Offline

2014/07/23 - 19:57

Dear Friends
I have updated my PIPO M9 Pro 3g before, however, this time using both the Kasty rom and PIPO update firmware I open Rock Chip Batch Tool add the firmware, connect the tablet the relevant box goes pink when I choose restore I get a message in red PIPO M9 Pro 3g When disconnected the tablet continues to work.
I would be most grateful for suggestions to resolve the issue and I can add screen shot if helpful
Thank you
Jude

uli-hh

Active Member

Forum Posts: 31

Member Since:
2013/09/03

Offline

Thanks Received: 8

2014/07/23 - 21:46

Did you press the “ESC“&“power” key for a few seconds to bring the tab into flash mode? Or try to press the switch button for this.

The device box should turn to green - then press restore button to flash.

Jude TJ

New Member

Forum Posts: 9

Member Since:
2013/11/12

Offline

2014/07/23 - 22:58

No I didn't but I will thank you

Jude TJ

New Member

Forum Posts: 9

Member Since:
2013/11/12

Offline

2014/07/24 - 00:02

Did this all went well until layer 7.4 then it went red fail. Now it won't even turn on should I download the firmware again reload in batchtool and try power escape and reset to restore?

Thamks Jude

uli-hh

Active Member

Forum Posts: 31

Member Since:
2013/09/03

Offline

Thanks Received: 8

2014/07/24 - 00:38

Try it again.

From what rom to what rom you are trying to flash?

Jude TJ

New Member

Forum Posts: 9

Member Since:
2013/11/12

Offline

2014/07/24 - 20:00

I had 4.2.2 30 October 2013 downloaded from the PIPO website. Tablet was running slowly and the bench tests were dreadful so I downloaded 4.2.2 24 June 2014 from the PIPO website and the Kasty Rom version too.

When I tried to update first time I didn't use ESC + Power before restoring so I couldn't update 2nd time I did it correctly but as above at layer 7.4 it went red and failed now I can't power it up.

Thank you