Forum switched to read-only as of 2020/06/01
|Latest product reviews|
Hello everyone I am new here, my arnova 7g3 tablet dosent start up anymore. What really happened was it was always getting stuck at Arnova boot up screen and i saw a topic about that same problem in this sub forum. So the solution was to flash the elvish firmware and that is what I did but after flashing the tablet actually started up but then went blank and now it dosent start anymore, when i press power button it comes on for about 3 seconds with some lines running through the screen then turns back off and my pc does not detect it anymore when i plug it in to usb. So can anyone help me?
Does the red light on the side come on? If it does, it could need a new otg cord to have the pc see it. The jack is probably anchored to the circuit board by the solder joints alone. Easy to break a trace without adequate strain relief. Still hope it's the cord. Otherwise, open it up and resolder with a lot of flux and a magnifier. Also, try holding the power button for a minute or two for a possible recovery screen, don't have that os on mine...
Most Users Ever Online: 749
Currently Online: vitzloi, Robi6666
Currently Browsing this Page:
Devices in use: Desktop (90), Phone (21), Tablet (1)
Guest Posters: 43
Moderators: globula_neagra, exelletor, JochenKauz, Oma7144, cracktech